|
Fast Jack
Installation Guide |
- Patented
single lag bolt design Patent No. 6,360,491
-
Independently laboratory tested to
3,600 lbs ultimate pull out,
1,380 lbs ultimate side axial loads
- Lightweight and
corrosion resistant Aluminum and Stainless Steel
materials (no inferior ferrous metals which rust and weaken over
time)
- Solid
Aluminum post prevents water funneling down through top of post
- No welds to
corrode or break
- 1" OD post
diameter (1-1/2" OD base diameter) compatible with standard
3/4" UPC / NES approved flashings (no expensive custom
flashings required)
-
Leveling kit available to accommodate roof height variation
|
 |
|
If you have a concrete tile
roof (either flat or s-tile) this is the structural attachment
of choice |
Tile Trac Installation Guide
|
Easy
to install
Patented single
lag bolt design
Patent
#5,746,091
Independently laboratory tested to1,740
lbs ultimate pullout load
Most cost effective,
water tight seal, tile attachment
12 years of industry
preferred design
No tile replacement
needed
Stainless Steel
and Aluminum design
10 square inches of
base evenly distributes roof load
Available in 6”
stud for S-Curve tile and 4” for Flat tile
|
 |
|
If you have a flat roof
this is the structural attachment of choice |
Solar Wedge Installation
Guide |
Available in 5,
10, or 15 degree tilt angles on flat roofs
Lightweight roof
load friendly design avoids restricting water flow which results in
excessive roof loads
Corrosion resistant
Aluminum and Stainless Steel material (no inferior ferrous
metals which rust and weaken over time)
Solid Aluminum
post prevents water funneling down through top of post
No welds to corrode or
break
|
 |
